Command

Description

Router#show interfaces

Displays statistics for all interfaces

Router#show interface e0

Displays statistics of e0 interface. You may use other interface also.

Router#show ip interface brief

Displays a summary of all interfaces, including status and IP address assigned

Router#show controllers serial 0

Displays statistics for interface hardware. Statistics display if the clock rate is set and if the cable is DCE, DTE, or not attached

Router#show clock

Displays the router clock.

Router#show hosts

Displays local host-to-IP address addresses of hosts on the network to which you can connect

Router#show users

Displays all users connected to device

Router#show history

Displays history of commands used

Router#show flash

Displays info about Flash memory

Router#show version

Displays info about loaded software

Router#show arp

Displays the ARP table

Router#show protocols

Displays status of configured Layer 3 protocols

Router#show startup-config

Displays configuration saved in NVRAM

Router#show running-config

Displays configuration currently running in RAM